SmokedBBQSource is supported by its readers. We may earn an affiliate commission at no extra cost to you if you buy through a link on this page. Learn more.
Perhaps you have just purchased an electric smoker. Or you have heard how convenient they are and are thinking about buying one yourself.
You could spend loads of time scouring the web for tips and tricks about how to get the best out of your new smoker, but we’re sure you’d rather just get out there and start smoking! So to save you time, we have listed 9 top tips mastering your electric smoker.
Electric Smoker Tips for Begginers & Experts
1. Ditch the chip tray
If you have an electric smoker, you may be familiar with how inconvenient and quite frankly inadequate chip trays can be. A small chip tray needs to be refilled several times throughout the smoke, and often the results are disappointing – bland food without much of a smoky flavor.
For these reasons, many barbecue enthusiasts out there have left the chip tray behind; in favor of a small tubethat gives off up to 4 hours or box which gives off up to 11 hours of thin, blue smoke — the Buzzlett Pellet Smoker.
This pellet smoker is inexpensive, very easy to use, and provides consistent smoke.
All you need to do is load the tray with pellets, ensuring the pellets are below the ridge of the dividers in the tray.
Light the pellets with a lighter or blowtorch. You might need to apply the heat for around 45 seconds. Once the pellets are alight, blow out the flames. This video shows how you can use a pellet smoker to add extra smoke when you cook.
Place the tray in the smoker, open your vent, and sit back and relax. A full tray of pellets should provide enough smoke for ribs, turkey legs or similar sized cuts.
Experiment a little with how much smoke you like. You can light the pellet in the tray from both ends if you like a little more smoke density. I hate to state the obvious, but it will burn out in half the time if you decide to burn from both ends.
2. Don’t oversmoke your food
Remember that more is not more when it comes to smoke. Generally, it is surprising how little smoke is needed to create a top-notch flavor.
While there will be a period of experimentation (which is half the fun), don’t forget that, especially in the case of poultry, food that is over-smoked can become pretty much inedible.
You will likely only need to use one tray of chips/pellets when cooking chicken to get a decent flavor.
3. Smoke chicken on a hotter setting
Chicken is not a meat that you cook “low and slow”.
In fact, the temperature you should be aiming to smoke chicken is around 275°F. The cook should take around 1 ½ to 2 hours.
Especially when cooking chicken, it is vital that the meat is properly cooked. As you probably know, undercooked chicken is dangerous.
The best way to check that the chicken is done is to check the internal temperature of the meat. The internal temperature needs to reach 165°F before it is cooked and safe to eat.
Judging whether the meat is cooked simply by counting the time the chicken has been cooking is not a reliable enough measure.
Check out this page for a list of all our best smoker recipes.
4. Learn how to control temperature swings
At the beginning of a smoke, the temperature inside an electric smoker is renowned for ‘swinging’. Sometimes, this can be up to 20°F above or below the set temperature.
To understand how to control these swings, let’s have a look at why they happen.
If you set your cooker to a certain temperature, say, 220°F, the temperature will rise until it hits this point. The heating element will stop once this temperature is reached, however, due to a slight lag, the internal temperature in the cooker will continue to rise of its own accord for some time.
How high the temperature climbs depends on a few things, like the temperature outside, or how windy it is.
Eventually, the temperature will start to drop again. Once the temperature has dipped back down to your set temperature, the element will come on again. However, the temperature will continue to fall below your set temperature until the effect of the element kicks in. Again, this is due to the time lag.
Therefore, if you want the temperature inside your cooker to be 220°F, try setting the smoker at 205°F or 210°F.
You will need to watch the temperature as it climbs. Once the internal temperature hits your actual desired temperature (220°F), as it climbs above the temperature you actually set (210°F), reset the temperature to 220°F on the controller.
By using this method, you will reduce the temperature “swing” as your cooker won’t have to work to compensate for the difference between the set temperature and the actual temperature.
Hopefully you did your research when you were looking at smokers and picked a model that was well insulated. If you’re still thinking about buying, we’ve got a guide to the best electric smokers here.
You may need to make some further fine adjustments to the set temperature to reduce the “swing” even further. Once you have experimented a little, you should be able to get your smoker running pretty close to temperature from the get go.
5. For cold smoking, use the attachment
Your cooker will likely have the option of a cold smoker attachment. If you can’t get your hands on one, pellet smoking devices will perform a similar function.
The Masterbuilt cold smoker attachment, for instance, will provide up to 6 hours of consistent smoke. It uses regular wood chips and attaches to your digital smoker.
These attachments will smoke at temperatures as low as 100 – 120°F, making them perfect for cold smoking products such as cheeses.
Generally you do not need to season your cold smoker attachment, although you do need to use it with a seasoned smoker. To be sure, read the manufacturer’s guidelines for the attachment you purchase.
A couple of tips when using these attachments:
- As with electric smokers, do not soak the chips you plan to smoke.
- When lighting the chips to smoke, do not be afraid of letting them flame up initially. To get good smoke, there needs to be adequate temperature. Wait until you are getting thin, blue smoke before you subject the food to the smoke.
6. Control your vent position
While finding the right vent position can be a bit of a challenge when you are using a charcoal smoker, it is not that complicated when you use an electric smoker.
As a rule of thumb, it is best to leave the vent fully open while you are applying smoke to your meat. By leaving the vent completely open, you avoid the risk of creosote building up on your meat.
Creosote is a compound in smoke, which, in small amounts, helps create the distinctive smokey flavor we love. However, it can quickly become very nasty indeed. While a very small amount of creosote in your smoke is a good thing, a coating of creosote on your food will make it taste terrible.
Generally speaking, the only time you should close your vent while you are cooking is when you have finished smoking your meat and simply want to raise the internal temperature inside the smoker.
7. Use foil on your grill racks to make clean up a lot easier
This is more of a housekeeping tip, but let’s be honest, anything that saves time on the cleanup is welcome advice.
Aside from being a matter of efficiency, clean grill racks equal better barbecue results.
Any leftover grease and oil on your grates will go rancid. This grease and oil can stick to your food, and can also produce smoke when it gets hot as you cook. The net result? It will make your food taste bad.
You can also use foil to cover your heat deflector pan and drip pan.
8. Don’t soak your wood chips
You might decide to stick with chips to create your smoke, and that is completely up to you – we don’t judge here.
But if you do decide to use chips, there really is no need to soak them.
The reason? The white “smoke” that comes off these soaked chips is not actually smoke at all.
Meathead Goldwyn of Amazingribs.com sums it up nice and simply:
“You might think you see smoke when you toss on wet wood, but it is really steam”.
The aim when smoking is to create thin, blue smoke. This is the type of smoke that imparts that really tasty, smokey flavor that we are all striving for.
White, billowy steam can also make temperature control more of a challenge as all that moisture evaporates out of your chips.
It is also liable to cause components of your smoker to rust.
9. Pre-season your smoker before using it for the first time
It may seem like a real pain-in-the-rump extra step to have to season your smoker before you use it. But believe me, there are good reasons to do so.
First, it will ensure that any nasty residue from the manufacturing process is removed before you actually cook food in your smoker. By this we mean petroleum based products, solvents and dust.
The fine layer of smoke that leaves a black coating over everything inside not only helps cure and seal the inside of your smoker, it adds to the smokey flavor of whatever you cook.
You can find more detail about how to season your electric smoker, and even more reasons why it is important in this post, just in case you aren’t convinced by this little recap.
10. Finish poultry in the oven for crisp skin
Some electric smokers max out the temperature at around 275° which isn’t quite hot enough to crisp up the skin on poultry.
It will still do the job and taste delicious, but for truly crispy skin try taking your chicken or turkey out of the smoker just before it’s cooked and finishing it in a hot oven for 10 minutes to get the skin nice and crispy.
Wrapping it up
We hope you have enjoyed the list of our top tips that will help you smoke like a pro in your electric smoker. Do you have any other tips you would like to share, or do you have some questions that we didn’t touch on in this post? Be sure to leave a comment in the section below.
And if you found this article useful, be sure to share!
Feature CC Image courtesy ofChepneron Flickr
Every time your wood chips burn up and you stop seeing smoke, you'll want to add more wood chips to the wood tray and hold the door open slightly so some heat can escape, forcing the heating element to come back on and get the wood to smoking.How do I get my Masterbuilt smoker to smoke more? ›
Every time your wood chips burn up and you stop seeing smoke, you'll want to add more wood chips to the wood tray and hold the door open slightly so some heat can escape, forcing the heating element to come back on and get the wood to smoking.Should vents be open or closed when smoking? ›
The open vents will draw smoke from the charcoal and wood below so that it swirls over your food and out the top properly, giving you the best ventilation and the cleanest smoke. If the fire gets too hot, close the top vent almost all the way.Should an electric smoker smoke the whole time? ›
People whose taste buds like a powerful punch like to smoke their meat all the way through a cook, re-adding chips when needed. But if you prefer a slight smokey hint, then we would suggest to only smoke for the first 30 to 45 minutes of a cook, then remove the tray and do not refill with anymore.How do I get the most smoke out of my electric smoker? ›
- Ditch the chip tray.
- Don't oversmoke your food.
- Smoke chicken on a hotter setting.
- Learn how to control temperature swings.
- For cold smoking, use the attachment.
- Control your vent position.
- Use foil on your grill racks to make clean up a lot easier.
- Don't soak your wood chips.
You Do Not Need to Soak Wood Chips. The most popular, and most argued about, tip when it comes to smoking is the soaking of your wood chips and chunks for at least an hour before smoking. The thought is that doing this will slow combustion and create a better-flavored smoke than dry wood would.Does opening the vents on a smoker make it hotter or colder? ›
Regardless of which vent you're messing with, remember that open vents mean hotter and faster-burning charcoal. Closed vents mean less oxygen, which in turn means less heat and slower-burning charcoal.Should there always be smoke coming out of smoker? ›
For example, your smoker should let out enough smoke for the food to cook properly. If there is too much smoke or too little smoke, then this could be a cause for concern.Why am I not getting smoke from my electric smoker? ›
Using an Electric Royal Oak Smoker
To get the maximum smoke time, you should be using unsoaked chunks, not soaked chips. Placing any metal objects on the element will greatly shorten element life. Just place a decent sized chunk of wood between the element, making sure it's not touching, and it will smoke just fine.
Cook at lower temperatures
For example, when cooking at 225°F you can expect to get significantly more smoke than if you were cooking at 450°F. If you are following a recipe that calls for temps above 225°F-250°F you can always give it a few hours at 225°F before ramping the temp up.
Do I need to flip my meat when smoking on the grill? NO! Sorry for being so brash, but this is a common mistake that many novice smokers will make. When smoking, you don't have to worry about one side getting hotter than the other, because the meat cooks indirectly.What is the best temperature for an electric smoker? ›
Aim for a target of 225°F (107°C). Use a purpose-made smoker thermometer for more accurate results. Different electric smokers will take different amounts of time to warm up, so to get an accurate sense of how long it'll take for your meat to smoke it's important to bring them to the right temperature first.How often do you put smoke chips in an electric smoker? ›
The number of woodchips you use will depend on how long you'll be smoking meat. Remember to keep adding new woodchips to the tray every hour of cooking time to keep the flavors rich.Why is my smoker not producing much smoke? ›
A heating element turned off means it can't produce heat to smolder the wood chips, which is necessary to create the smoke. So, if you're operating your smoker while the outside temperature is elevated, ensure your smoker is staying on while you're cooking.Why is my Masterbuilt electric smoker not getting hot enough? ›
Key Takeaway: If your Masterbuilt smoker isn't getting hot enough, ensure the temperature controller is free of moisture or dust to get an accurate reading. Next, open the vents to allow heat to build. Lastly, if you're using a charcoal smoker, ensure there's enough charcoal in the firebox.